Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations strongm on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

H3C S5120-SI 802.1q qinq setup

Status
Not open for further replies.

MayfairBlues

Technical User
Nov 28, 2011
2
0
0
GB
Hi

Trying to enable basic qinq on the H3C S5120 switch. Couple of question can you do this on the non enterprise version? Secondly can it be done via telnet session. Telnet rights is level 3, command used (but fails) qinq enable.

system-view
interface gigabitethernet 1/0/17
qinq enable

after that it responds % Unrecognized command found at '^' position.
^ is the letter q at the start of qinq enable
 
Well, it´s simple. QinQ is not supported on S5120. I think you need at least the S5500 was it -EI(?) series for this
 
After eventually getting through to H3C support they confirmed the with software update then qinq is supported.
 
Seems I was wrong, sorry for this.

According to 5120SI-CMW520-R1505P07 Release Notes QinQ is supported.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top