H323 End point with CS1000

[tabsnz]

Group,

I want to attach a Audiocodes MP114 to a CS1000, we have managed to get the box to register, but we cannot progress to dial ( we get dial tone and we can dial - but timeout occurs.)

We suspect the dial plan is incorrect but no one is sure, we have a Cisco ATA working fine , so we tried to copy the setings for that - but no go.

Do anyone have an "Idiots guide to connecting any H323 endpoint to a CS1000? "

Thanks in advance - Paul

 

[dlesap]

That's the more common fault.
First: Did your ATA is registered in NRS?
Second: Routing entries must exist for incoming calls from PBX to ATA
Third: The problem is in your ATA config. Go to "DTMF and Dialing" menu and validate all protocols in DTMF options.

Give prints if more infos are necessary to help you

 

[tabsnz]

Thanks for the assistance, I cannot check this immediately as I cannot get access tothe CS1000 till 23rd Jan. I really appreciate the pointers and will implement as sson as I can, hopefully your offer to further help will be still avalaible

 

[tabsnz]

Thanks - we got this working - the route codes were incorrect