GDC480H, WTIBE, GDC600BE, IPLDK100

[eats4treats]

Hi

Double cab IPLDK100 3.8ct

Just installed WTIBE and have a GDC600BE wired straight to the card without the barrier boxes (This might be the issue???)

The 3 x GDC480H dects register fine to the base station and are given an allocated extension number.

The DECTS have no voice internally or externally, it rings and rings out but has no voice.

The DIP switches on the card are correct.

Does the base still function correct if wired straight to the card? If not and have to use the barrier boxes, is there a specific wiring termination or can you just match up the connectors using CAT5e cable?

Eats.

Ok, Press Trans *#..... TRANS/PGM..... the transfer key?.......sigh!

 

[Thermus]

Hi eats

I have only installed GDC600BE to LDK on software version 3.9JB. I also upgraded the WTIBE to the latest version.

I also always connect directly to the card first to make sure the aerial is working.

I will try to find the software for the WTIBE upgrade if you want it. I remember the instructions came as if they were for the IPECs WTIM, but it did work fine for the LDK