Hello dear fellows!
Again is me asking for something, I hope one day I can share too. I think this year I am going to break my record of open more than one thread a year ?
I am trying to set up a G450 with LSP.
Not using AIW.
I execute the following commands
G450-???(super)# set vlan xxx name voice
G450-???(super)# int vlan xxx
G450-???(super-if:Vlan xxx)# ip address 10.xx.xx.xx 255.255.255.0
G450-???(super)# set port vlan enable10/5
G450-??? (super)# set port duplex 10/5 full
G450-??? (super)# set port speed10/5 100MB
G450-??? (super)# set port vlan xxx 10/5
G450-??? (super)# set port vlan-binding-mode 10/5 bind-to-configured
Between all these commands you can add several copy running config…
The media Gateway register on main server in few minutes, but LSP didn’t get registered at all.
Somebody point out to me that another command should be execute at the G450 prompt, that command is “ip register” or “ip license server”, I don’t remember.
After that command execution my LSP register on main server.
Someone can help me on that command?
If someone has a guide on how to get the G450 programmed step-by-step using CLI and want to share, I am sure lot of people like me will appreciate.
I am quite sure I forget a lot of things (like sync, just remember now while writing this message) that is way I would love is someone share with us that piece of info.
Thanks in advance
Again is me asking for something, I hope one day I can share too. I think this year I am going to break my record of open more than one thread a year ?
I am trying to set up a G450 with LSP.
Not using AIW.
I execute the following commands
G450-???(super)# set vlan xxx name voice
G450-???(super)# int vlan xxx
G450-???(super-if:Vlan xxx)# ip address 10.xx.xx.xx 255.255.255.0
G450-???(super)# set port vlan enable10/5
G450-??? (super)# set port duplex 10/5 full
G450-??? (super)# set port speed10/5 100MB
G450-??? (super)# set port vlan xxx 10/5
G450-??? (super)# set port vlan-binding-mode 10/5 bind-to-configured
Between all these commands you can add several copy running config…
The media Gateway register on main server in few minutes, but LSP didn’t get registered at all.
Somebody point out to me that another command should be execute at the G450 prompt, that command is “ip register” or “ip license server”, I don’t remember.
After that command execution my LSP register on main server.
Someone can help me on that command?
If someone has a guide on how to get the G450 programmed step-by-step using CLI and want to share, I am sure lot of people like me will appreciate.
I am quite sure I forget a lot of things (like sync, just remember now while writing this message) that is way I would love is someone share with us that piece of info.
Thanks in advance