frquent high call rate in LIM of MD110-tsw System

[coolfalcon]

dear all
i have a 8 lim md110-tsw system, and i have a frequent high call rate alarm on LIM2 all extensions on the gives congestion
the LIM is of two magazines with TRU and TSU boards and its
almost fully equiped. i print out all equipements in the BLFDP command and Manual block them, but the problem still exist since
two weeks . can one help me ?
thanks alot

 

[himdp]

Any lost signals in HIMDP?

 

[coolfalcon]

sorry can you explain me what to do?

 

[coolfalcon]

can i send you them HIMDP file?

 

[himdp]

If you do HIMDP:LIM=2; do you get many lost signals and do they correspond to the times you get the 320 alarms? I have seen a problem several times where a faulty analogue extension is producing many false calls which swamps the LIM and uses all the resources in RM. This type of fault was accompanied by lost signals. Just a thought.

 

[batkotivalio]

I've seen this alarm due to problem with cable. Try LSCOP:LIM=2 to determine which subscriber to disconnect on MDF.(they are marked "part of fan"...)

 

[coolfalcon]

Thanks alot for your help
i tried to find out lost of signal in the himdp file during the
high call rate fault but i could not found.and also i tried the
command LSCOP:LIM=2; i found to equipments gives the following
2-0-30-09 2-0-12-03 2 PART OF FAN 2 ELP6 H'01B0
2-0-11-06 "
END
i test the extensions initiated at that equipments on MDF and they are working properly
i tired to block all the faulty equipmets in the BLFDP output
and now the problem dissapeared since two days