Foxaudit DBC setup error

[nickpatel]

I am running the DBC Setup wizard in foxaudit 8.0. After I select the project in step 7, foxaudit tries to create the tables. I am getting an error message on screen saying

13 Alias 'L' is not found. USE...
OK or Cancel

the 'L' it is referring to is my L drive where the project is located. There is also a wait window on screen saying:

Building transaction log primary key table

I hit ok and a messagebox comes up saying:

problem building log table

I hit ok and everything runs through fine. Then I get a messagebox saying:

1206 Recursive macro definition. Set path to &Environment[9,1]

This doesn't happen when I have the project on my local drive. Is this a bug or I'm I doing something wrong here? I'm following step by step from the manual.

thanks
Nick Patel

 

[rgbean]

Nick,
Since most of us aren't likely using FoxAudit, I'd suggest you directly contact TakeNote Technologies at support@takenote.com and ask them. I know Jim is usually very quick with his responses - unless he happens to be out of town training, and then it's usually not very long.

Note: Does this path have a space anywhere in it? Does the local path have any spaces?

Rick

 

[nickpatel]

I've emailed him again, (I did once in past long time ago and didn't get an answer). I don't have any spaces in the paths at all. If I hear anything, I'll post it on this thread.

thanks
nick