Flex Button Programming IPLDK-20 System

[samharris123]

Hello,

This might be very simple to someone but I am really struggling.

I have created a system speed bin (2010) which works when using the speed button. I am pressing [TRANS/PGM] > * # > [TRANS/PGM] > 115.

I do not know where to go from there. If someone could help I would be very thankful.

 

[eats4treats]

samharris123

Your question is slightly confusing.

Do you need program a speed number on 2010? Do you want to program a flex button to use as speed 2010?

What system are you using? I can then assist with the programming.

If its what I'm thinking, you can do the following to program a button:

Trans/Pgm
Press required spare flex button
Press Speed
Dial 2010
Press Hold/Save
Press Speaker

If you receive error tone when pressing Hold/Save then that button is a line key and must be deleted in system programming first.

Eats



Ok, Press Trans *#..... TRANS/PGM..... the transfer key?.......sigh!

 

[samharris123]

Hello eats4treats,

Sorry for the delay getting back to you.

You method was exactly what I needed, thank you very much.

Sam