Filtered Address?

[LLudlow]

I have 2 routers over a WAN link with different subnets. On one subnet (10.0.10.0) i have my mail server, the other subnet (10.0.19.0) is just a remote site with very few users. All of the users from the 10.0.19.0 subnet can reach everything on the 10.0.10.0 subnet except for one server, the mail server. And everyone else in other remote areas can reach the mail server as well, just this one site is having problems. I have tried to set up an access list for the 10.0.19.0 site but that makes no difference and there are no access-list denies in the config file. I have a static route between these two sites. Does anyone have any suggestions why this one IP Address would be unreachable.

Thanks

 

[eurobadger]

The usual 'gotcha' is the implicit 'deny all' at the end of the access list.

 

[StarTAC]

right, check your access list config.. u may dump it here, for more help..

else, u may need to check your mail server config to that network..

good luck..