thans for your response
by hyper following data are seen it seem Error: couldn't load any loadware image!
RS232 initialized for Output: 38400,8,n,1
loading FPGA: Load O.K.
testing Checksum Firmware: Test O.K.
testing Data-Bus DRAM: Test O.K.
testing Address-Bus DRAM: Test O.K.
testing Pattern 0x55555555: Test O.K.
testing Pattern 0xAAAAAAAA: Test O.K.
FPGA Registers access: Test O.K.
testing ICGX Registers: Test O.K.
testing PHY identifier value: Test O.K.
Board Selftest complete
**************************************************
* NCUI2
**************************************************
Copyright 2002 Siemens AG
Hardware ID : 0x0830
Serial Number : SN473063340110
Parts List Version : -02
Bootrom Version : NCUI2+_FW_060330
Processor speed = 266 MHz
PLB speed = 133 MHz
OPB speed = 44 MHz
Ext Bus speed = 33 MHz
FPGA Version : 9
Ethernet Address 1 : 00:0F:BB:0D:F0:2C
Ethernet Address 2 : 00:0F:BB:0D:F0:2D
CPU - Type : IBM PowerNP NPe405H Rev. A Rev. 0140
- Frequency : 266 MHz
Flash Memory : 32 MByte
DRAM Module : 128 MByte (SDRAM PC133 )
DSP Modules :
DSP Module 0 present: YES - type: "6416"
HGA Modules:
HGA Module 0 present: YES - type: "PDMX-X000"
HGA Module 1 present: NO - type: "None"
Shelf ID : 0 = AP3700IP (SAPP Base Box)
!! Attention: Power Supply of Base Box is out of range !!!
System date: SAT JAN 01 00:00:00 2000
/tffs/ - disk check in progress ...
/tffs/ - Volume is OK
total # of clusters: 15,550
# of free clusters: 7,1
# of bad clusters: 0
total free space: 14,292 Kb
max contiguous free space: 14,276,608 bytes
# of files: 347
# of folders: 11
total bytes in files: 16,378 Kb
# of lost chains: 0
total bytes in lost chains: 0
*******************************************
/tffs - directory Entries:
Type: Size: Name: LW image from: act:
file 65 bootline.bck
file 10 BOOT_CLI.psw
file 8192653 SW_IMAGE.001 09/15/11 14:21:59
file 65 bootline.act
file 1490 boarddat.bin
dir 2048 core_log
dir 2048 cgw_data
dir 2048 etc
dir 2048 evtlog
dir 2048 trace
dir 2048 siu_data
file 7565354 SW_IMAGE.002 09/15/11 14:13:00
file 1 apemem.bin
file 61 lwheader.bin.tmp
file 0 ssl.on
file 0 tgt_shell.on
file 0 service_center.on
file 104 Version.001
dir 2048 admlog
dir 2048 ppplog
dir 2048 custtrc
file 61 lwheader.bin
file 88 mekdata_enc.bin
file 104 Version.002
dir 2048 REBOOT
file 1 HIPATH
Total TFFS size: 31846400 bytes / free: 14635008 bytes
SW_IMAGE.001 09/15/11 14:21:59
SW_IMAGE.002 09/15/1
Press any key to stop auto-boot...
0
auto-booting...
Try to load image file SW_IMAGE.001.
Version: pzknci40.28.005-
Try to load image file SW_IMAGE.001.
Version: pzknci40.28.005-
Try to load image file SW_IMAGE.001.
Version: pzknci40.28.005-
Try to load image file SW_IMAGE.001.
Version: pzknci40.28.005-
Error: couldn't load any loadware image!
Boot password:
Error: wrong password.
Boot password:
[NCUI2 Boot CLI]: REBOOT
Remove directory.
Input sub directory name:
help
Error: /tffs/help is not a directory!
[NCUI2 Boot CLI]:
[NCUI2 Boot CLI]:
