Hihi
Im trying to create disk mirror set on an old Custom built PC, this is the set up so far ..
2.5 Gb WD-caviar (primary Master)
2.5 Gb WD-caviar (primary Slave)
CD-ROM (2nd Master)
2.5 Gb WD-caviar (2nd Slave)
everything sworks fine, butim trying to create a disk stripe set with parity or disk mirroring, normally if i just highlight the partion and hold down the control key and choose the other partition im able to choose 1 of the options under fault tolerence, but the prob is when i try holding down the Ctrl key , it dosent old the last drive selectiion and theres no wya i can get the fault tolerence option going.
Can some 1 plz tell me what im doing wrong or where i ve gone wrong?
Many Thx
Im trying to create disk mirror set on an old Custom built PC, this is the set up so far ..
2.5 Gb WD-caviar (primary Master)
2.5 Gb WD-caviar (primary Slave)
CD-ROM (2nd Master)
2.5 Gb WD-caviar (2nd Slave)
everything sworks fine, butim trying to create a disk stripe set with parity or disk mirroring, normally if i just highlight the partion and hold down the control key and choose the other partition im able to choose 1 of the options under fault tolerence, but the prob is when i try holding down the Ctrl key , it dosent old the last drive selectiion and theres no wya i can get the fault tolerence option going.
Can some 1 plz tell me what im doing wrong or where i ve gone wrong?
Many Thx