failed controller w/ raid manager

[ponetguy2]

Hello Gurus,

I have two A1000s connected to the same controller. I know, this is
not a good setup, but I had no choice. This controller has gone bad.
We were able to install another controller and we are going to move the
A1000s to the new dual port controller. Am I going to loose my LUN
configuration if I move the A1000s to the new controller? Is there a
procedure for this? Am I out of luck, where I will loose all my config
and data if I move the disk arrays to the new controller?

Solaris 9 w/ RAID Manager 6.2.

Please help.

 

[ponetguy2]

i replaced the controller on the a1000 and it's still dead.

looks like i have a very expensive door stop on my hand. jk

luckily, my boss told me that this a1000 is still under waranty. i'll try to get it replaced.