Factory Defaults on a PIX 515

[CokeandSushi]

Hi All

I have just been handed a PIX 515 (no FDD support) firewall from a company we took over a few years back.

Since no one is left from the firm I don't have the passwords.

I am looking at resetting it to factory defaults so I can use it for other tasks.

But I require the IP address of the e0 port (which I don't have) so I can send the bin file to the device.

Any ideas how else I can reset the factory default config?

I don't want the old config.

 

[CokeandSushi]

OK I figured it out the e0 port is stuffed.

Thanks anywho.

 

[rrgg]

If you want to reset password to factory default you can follow this document:

http://www.cisco.com/warp/public/110/34.shtml

After this if you want to reset configuration to fatory default you write this:

WRITE ERASE
REBOOT

Bye.