external name display not working

[bizzaro]

I have a PRI configured for NI2. We have always been able to see the exernal line ID. We just subscribed to caller ID and I am unable to see the name of the external caller. Here is a snapshot of my RDB and D-CH configuration. Do I to add ND2 to RCAP? As long as I am configured for IFC = NI2, I am unable to add ND2 to RCAP. I turned on messaging for the inbound D-Channel, but I never saw any names.

* ROUTE *
TKTP DID
NPID_TBL_NUM 0
SAT NO
RCLS EXT
DTRK YES
DGTP PRI
ISDN YES
MODE PRA
IFC NI2
CBCR NO
NCOS 0
SBN NO
PNI 00000
NCNA YES
NCRD YES
CHTY BCH
CPFXS YES
CPUB OFF
DAPC NO
BCOT 0
INTC NO
DSEL VOD
PTYP PRI
AUTO NO
DNIS NO
DCDR NO
ICOG IAO
RANX NO
SRCH LIN
TRMB YES

* D-Channel *
USR PRI
DCHL 19
OTBF 32
PARM RS422 DTE
DRAT 64KC
CLOK EXT
IFC NI2
ISDN_MCNT 300
CLID OPT0
CO_TYPE STD
SIDE USR
CNEG 1
RLS ID 1
RCAP COLP NDS

 

[johnpoole]

look at the rcap on your d, and you might want to go to ld 96 and enl msgi x on that d to make sure your getting names

john poole
bellsouth business
columbia,sc

 

[jamie2]

Try changing your CO_Type type to 'CO_TYPE ATT' on the dch.

 

[johnpoole]

RCAP COLP NDS.. my bad, read the post during a conf call you've got name display,nds, is nd2 and nd3 still an option? not at work with the books.. type att may be all that is needed, but until i verified via ld 96 i wouldn't make a lot of changes.. trmb yes is not causing that problem but it can cause other problems.. when you bring one up, i've seen that cause it to not auto establish.. if you see that, turn it off..

john poole
bellsouth business
columbia,sc

 

[bizzaro]

I was unable to add nd2 to the rcap. I think it is because the ifc = ni2. I am connected to a DMS switch. I thought that if I am connected to a DMS, I use type = std and if it was a 4e/5e, type = att. Is this a correct assumption? When I try to add nd2, I get an error sch0531 which states:

Unable to match input with stored mnemonics. The RCAP prompt in overlay 16 has been answered NDS when QSUr QSIG GF are not accessible or with an inappropriate interface configured
(e.g. Sl 1).
Action: Reconfigure accordingly.
Severity: Info

I did not see an rcap prompt in the RDB.

 

[bizzaro]

I contacted the Carrier and after some time it all of a sudden started working.

 

[johnpoole]

it's strange how they never have a problem but then it gets well.. at least they are all alike.. that's why i always enl msgi x in 96, i need to see the names on the pipe before i start changing software

john poole
bellsouth business
columbia,sc