Hi, folks!
Anyone out there had experience configuring Access or VB for use with telephones -- specifically monitoring DTMF (phone tones), then branching depending on the key pressed?
Looking for code level here, because I'm developing an Acccess application controllable by inputs from telephone -- not looking for a stock application.
You folks have been SOOOOOO helpful in the past -- some very sharp folks here.
Thanks so much for any input you can provide!
Respectfully,
GWhiz
Anyone out there had experience configuring Access or VB for use with telephones -- specifically monitoring DTMF (phone tones), then branching depending on the key pressed?
Looking for code level here, because I'm developing an Acccess application controllable by inputs from telephone -- not looking for a stock application.
You folks have been SOOOOOO helpful in the past -- some very sharp folks here.
Thanks so much for any input you can provide!
Respectfully,
GWhiz