ERICSSON DECT590 1

[benaja75]

HI YOU ALL
when I switch on my dect I have this message:
enter IPEI, code:
Is there any solution?
Can someone help me?

 

[njohn343]

Sounds like the handset has been locked out by a user entering an incorrect PIN number too many times.

If you do a search of the forum for DECT you'll most likely find some previous threads on this topic.

 

[fouesnant]

Hello

Here is the solution
Enter the IPEI number as unblock code. If the IPEI number is unknown, it can be read out with the help of the programming cable and the Cordless Phone Manger program.
The IPEI number can be found in the "End-user PIN" menu in the Cordless Phone Manger program
The IPEI number can also be found in the DECT system (not applicable for the integrated DECT system in MD110).
When the phone has been unblocked and the user wants to active the phone lock again, the phone will ask for the old PIN code, if this is unknown, the PIN code can be restored to the default value (0000) by entering the Development Services menu (Call time > * < < * <) and selecting Default prg.

Good luck

 

[benaja75]

Thanks fouesnant,
I think I am on the way for the solution, but the problem is the command printout do not give me the IPEI,only a dash
this is the printout

cxakp:dir=2322;

cordless extension authentication key data

DIR AUTKEY IPEI ACCESS RIGHTS
2322 - - confimed

end

 

[singhbrindisi]

Hi,

Once a phone is registered succesfully, you can't see the IPEI with the command you are trying...
You are left with the solutions given by fouesnat...
I am not sure if the backdoor code as for DT29* series can be useful on this model...

Cheers,

""The truth about action must be known and the truth of inaction also must be known; even so the truth about prohibited action must be known. For mysterious are the ways of action""

 

[nschreuder]

Try this code: 0000707402170

It still workes fine for us.

Greetz.

 

[benaja75]

It's ok.
Thank a lot nccoi, I very appreciate your help.
It works very fine