eMG80 Sys Call Routing question

[Jonah29]

Hi everyone,

I have an eMG80 (Ver B.0Aa APR/14) on ISDN2e lines. Currently there is a System Call Routing scenario set up with a destination of Sys Speed 2000. When the system routes the call to the mobile number stored in SPD 2000, the main bearer number/CLIP is displayed on that mobile. Is it possible to change this to be one of the specific DDI numbers that is live on that ISDN2e bearer? I know it is possible to send the CLI of specific extension DDI’s to line when they dial out manually.

Thanks

 

[xs650]

I don´t know your ISDN2e lines but with my ISDN line it is working when I set
CLI Transit=original CLI in PGM151.

 

[martinhodge]

yes set your call routing up to send it to a dummy extension that has a fwd if out of service turned on . then set a unconditioncal call fwd to speed dial 2000 on that station. then set the cli attributes in the station attributes to be the ddi that you want on that isdn.