Easy questoin I hope?

[cbailey]

I am trying to configure two Cisco 802 routers linkig them via ISDN using CLI. Following the manual as a guide to setup both corporate and remote router and have a problem with a command.

When I get to "dialer map ip 10.3.1.2 name..." information; what is it looking at? Everytime I input some good numbers, I get flagged on the usage of the map command. I'm in the proper mode and I have not mistyped anything.

Any ideas? thanks

 

[stevensavage]

cbailey

Check the following - is your switch type entered and correct? What country are you in? What is the error message you receive?

Post a copy of one of the configs

cheers