surferxx60
Technical User
Does V12.2(7b) or V12.2(24b) software on the Cisco 7000 series support RFC2878?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Easy question - CISCO 7000 series 1
- Thread starter surferxx60
- Start date
- Status
-
1
- #2
CISCO-BCP-MIB
The CISCO-BCP-MIB (based on RFC 2878) (Bridging Control Protocol) contains objects to configure, enable, and disable bridge modules on both ends of point-to-point links. The Cisco 7600 series Internet router uses the BCP for transporting Ethernet frames over SONET and DPT networks. The BCP-MIB manages and monitors Bridge Control Protocol configuration and information on subnetwork interfaces using the family of Point-to-Point Protocols.
Currently, the following cards support the BCP (RFC 2878) on the Cisco 7600 platform:
OSM-4OC-12-POS-SI
OSM-2OC-12-POS-MM
OSM-4OC-3-POS-SI
OSM-8OC-3-POS-XX
OSM-16OC-3-POS-SI
OSM-1OC-48-POS-SX
OSM-2OC-48-POS-SX
I did not notice the advised version, I hope this helps.
“Reserve your right to think, for even to think wrongly is better than not to think at all”
Fisher CCNP,CCNA Network+
![[americanflag]](/data/assets/smilies/americanflag.gif "[americanflag] [americanflag]")
The CISCO-BCP-MIB (based on RFC 2878) (Bridging Control Protocol) contains objects to configure, enable, and disable bridge modules on both ends of point-to-point links. The Cisco 7600 series Internet router uses the BCP for transporting Ethernet frames over SONET and DPT networks. The BCP-MIB manages and monitors Bridge Control Protocol configuration and information on subnetwork interfaces using the family of Point-to-Point Protocols.
Currently, the following cards support the BCP (RFC 2878) on the Cisco 7600 platform:
OSM-4OC-12-POS-SI
OSM-2OC-12-POS-MM
OSM-4OC-3-POS-SI
OSM-8OC-3-POS-XX
OSM-16OC-3-POS-SI
OSM-1OC-48-POS-SX
OSM-2OC-48-POS-SX
I did not notice the advised version, I hope this helps.
“Reserve your right to think, for even to think wrongly is better than not to think at all”
Fisher CCNP,CCNA Network+
- Thread starter
- #3
surferxx60
Technical User
Thanks for that. Just wondering if 12.2(24b) s/w support RFC 2878?
- Status
Similar threads
- Locked
- Question