I receive an error when I attempt to run Call Status on my server. It was working at one point. I removed the whole Admin Suite and rebooted then reinstalled the whole admin suite again and I still get the same issue "EAccessViolation" then the software stops. Has anyone seen and/or resolved this issue? Any ideas?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations wOOdy-Soft on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
EAccess Violation starting Call Status 3
- Thread starter BURLYMAN
- Start date
-
3
- #2
Yep, I have. Here are the procedures to fix this.
My Computer > Properties
Advanced Tab
Performance > Settings
Data Execution Prevention Tab
This is turned on by default with a blank exception list.
Click Add...
Locate your copy of callstatus.exe
C:\Program Files\Avaya\IP Office\CallStatus\callstatus.exe
Click Apply > OK > OK
kristiandg
Programmer
Its an issue with the SP1 for 2k3 server. And really its not an "issue" but a function of the new security features in SP1.
There's an official document from Avaya that I've got, but I'm not quite sure where to post it. Its actually going to be a tech tip in the next few months, but it hasn't been released yet, nor assigned a tech tip ID.
Hope this helps...
Kris G.
There's an official document from Avaya that I've got, but I'm not quite sure where to post it. Its actually going to be a tech tip in the next few months, but it hasn't been released yet, nor assigned a tech tip ID.
Hope this helps...
Kris G.
- Status
