Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Dual PRI Card in an IP406v2

Status
Not open for further replies.

lanstar

IS-IT--Management
Joined
Jan 19, 2003
Messages
52
Location
US
I have an IP406v2 running 5.0.20. I am installing a dual PRI Card in Slot A and an ATM4 Card in Slot B. when I reboot the system the Line Config shows: Line 1 - PRI24, Line 2 - PRI24, Lines 3-8 - Analog Trunk. I don't know where the 2 extra analog Trunks are coming from or how to get rid of them. I tried switching the Slots but with the Dual PRI card in Slot B it only recognizes 1 PRI. I have found several places in the documentation thay say that the Dual PRI card can only go in Slot A.
Has anyone seen this or have any ideas?

Stephen E. Bradford
LANstar Technologies, Inc.
 
Remove the ATM4 and also remove it from the programming.
Reboot the ipo and then put back the ATM4.
If it is still there then i don't know :-)

Homo sapiens non urinat in ventum

honey, i fried the IP Office !!!

Sarcasm, it's only one of the services I offer.
 
Was the ATM4 in slot A originally?

| ACSS SME |
 
Yes. Originally I had the ATM4 in Slot A and the Dual PRI in Slot B. In that configuration, only 1 of the PRI's showed up in the config. I then powered it down, swapped the cards, powered it back up, erased the config in Manager and rebooted. Both PRI's showed up (as Line 1 & 2) but I also had 6 Analog Trunks (Lines 3-8). Very strange. I then took tlpeter's suggestion and it came back up just fine. I have powered down the unit a couple of times to make sure that it isn't just a fluke. It seems to be OK now. Thanks for all of the input.

Stephen E. Bradford
LANstar Technologies, Inc.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top