Hi folks,
One of my most valued users returned this week from basic BO usertraining and remarked upon an example shown to her by her teacher, which I cannot replicate back in the office.
It looks like something as a crossbreed between using drill down technique and using the outline function. With outline you can fold sections , with drilling you automatically create a drill-report where you go from value A from dimension 1 to the associated values 1 level down etc.
This, however (seen it last year , now I remember with some financial report from a consultant) acts like you fold open a next level within a tabel for that specific value within the table without affecting sections and without starting a drill report.
I realize I'm sounding rather vague but it looks like an outline functionality after removing the sections from outside the table. Has anyone a clue about my mystery and perhaps a hint how it is done? T. Blom
Information analist
Shimano Europe
tbl@shimano-eu.com
One of my most valued users returned this week from basic BO usertraining and remarked upon an example shown to her by her teacher, which I cannot replicate back in the office.
It looks like something as a crossbreed between using drill down technique and using the outline function. With outline you can fold sections , with drilling you automatically create a drill-report where you go from value A from dimension 1 to the associated values 1 level down etc.
This, however (seen it last year , now I remember with some financial report from a consultant) acts like you fold open a next level within a tabel for that specific value within the table without affecting sections and without starting a drill report.
I realize I'm sounding rather vague but it looks like an outline functionality after removing the sections from outside the table. Has anyone a clue about my mystery and perhaps a hint how it is done? T. Blom
Information analist
Shimano Europe
tbl@shimano-eu.com