Hi All
Has anyone ever setup a DDP2 card (NT5D97AD) for dual DPNSS setup.
Originally we had the first port (0) working in original addressing mode, which works fine. We've since set the jumper settings on the card to extended mode, and got the Port 0 link back up and running.
However Port 1 does not establish for DPNSS link, it stays in LOI state, in loopback or when connected to switch:
My questions are this:
1. Do we need the DCHI configured for Port 1, currently only configured for Port 0
2. Has anyone got this working before?
3. LOI
REQ prt
TYPE ddsl
DDSL 47
DDSL 47
S2 1
SIGL DA
DDCS 047
PRIV YES
SIDE AET
L2_RST YES
SAT NO
ALRM TBF 05(S) 00(H) 01
FAE 02(S) 01(H) 04
HER 01(M) 01(H) 10
TSF 00(S) 00(H) 00
AIS 01(M) 01(H) 04
LOI 00(S) 00(H) 00
DAI 01(M) 01(H) 05
CNTR CRT 120
TMT 50
SCT 20
NMT 100
MPT 2048
OTH 5
LDT 32
DTH 5
.stat ddsl 47
ENBL IDLE, ALRM LOI
.stat ddcs 47
02 UNEQ
60 DSBL
Has anyone ever setup a DDP2 card (NT5D97AD) for dual DPNSS setup.
Originally we had the first port (0) working in original addressing mode, which works fine. We've since set the jumper settings on the card to extended mode, and got the Port 0 link back up and running.
However Port 1 does not establish for DPNSS link, it stays in LOI state, in loopback or when connected to switch:
My questions are this:
1. Do we need the DCHI configured for Port 1, currently only configured for Port 0
2. Has anyone got this working before?
3. LOI
REQ prt
TYPE ddsl
DDSL 47
DDSL 47
S2 1
SIGL DA
DDCS 047
PRIV YES
SIDE AET
L2_RST YES
SAT NO
ALRM TBF 05(S) 00(H) 01
FAE 02(S) 01(H) 04
HER 01(M) 01(H) 10
TSF 00(S) 00(H) 00
AIS 01(M) 01(H) 04
LOI 00(S) 00(H) 00
DAI 01(M) 01(H) 05
CNTR CRT 120
TMT 50
SCT 20
NMT 100
MPT 2048
OTH 5
LDT 32
DTH 5
.stat ddsl 47
ENBL IDLE, ALRM LOI
.stat ddcs 47
02 UNEQ
60 DSBL
