Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Rhinorhino on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Does Anybody Know if a 3300 cx controller supports an ASU 2?
- Thread starter miteldude
- Start date
TheMitelGuy
IS-IT--Management
What release...
Quad CIMs are supported on the 3300 (you are limited to 3 of 4 ports, left to right).
ASU II (2) is supported on the CX/CXi controller as well.
Please check your software revisions and upgrade if required.
Quad CIMs are supported on the 3300 (you are limited to 3 of 4 ports, left to right).
ASU II (2) is supported on the CX/CXi controller as well.
Please check your software revisions and upgrade if required.
12345kevin
Vendor
The CX & CXi do not have any "cim" ports and cannot have asu's connected to them, you can however add an analogue expansion board.
TheMitelGuy
IS-IT--Management
12345kevin: I take it you are not certified?? Please do not post items to this board if you do not know what you are talking about. Sales people use this board as well for support during the sales cycle, and they need answers quickly and honestly. An error like yours could cost a VAR or customer money, simply for the sake of you posting...
Please review the manual.
From the manual:
=================
Table 3: Maximum CX/CXi configuration (continued)
CIM ports 3 One Quad CIM card can be installed, but only the first 3 ports will be functional.
Please review the manual.
From the manual:
=================
Table 3: Maximum CX/CXi configuration (continued)
CIM ports 3 One Quad CIM card can be installed, but only the first 3 ports will be functional.
12345kevin
Vendor
MitelGuy : Yes I am certified for longer than I care to remember, if i've made a mistake then I bow to your better judgement ! However I am currently looking at both a CX And CXi and there is physically nowhere for a CIM port to go ! And the manual reflects this within the "hardware" section. The bit you have read appears to be a "typo". Maybe the UK versions are different ! I doubt it though !
12345Kevin, From the technical update course for 7.1:
"You can install up to two Quad CIM's in any 3300 ICP Controller, with the exception of the AX controller which only supports one quad CIM.
On CX and CXi Controllers, only the first 3 prots on each Quad CIM are functional -- the fourth port is not supported"
MitelDude, it would appear you are good to go (as long as your software is 7.1 or better.
*******************************************************
If we don't take care of the customer, Maybe they'll stop bugging us.
"You can install up to two Quad CIM's in any 3300 ICP Controller, with the exception of the AX controller which only supports one quad CIM.
On CX and CXi Controllers, only the first 3 prots on each Quad CIM are functional -- the fourth port is not supported"
MitelDude, it would appear you are good to go (as long as your software is 7.1 or better.
*******************************************************
If we don't take care of the customer, Maybe they'll stop bugging us.
TheMitelGuy
IS-IT--Management
You place a CIM card in your MMZ slot.
All controllers are made in China for every market. The same controller is sold globally.
All controllers are made in China for every market. The same controller is sold globally.
- Status
Similar threads