murdof
IS-IT--Management
- Oct 23, 2003
- 31
Hi all,
I have an Ericsson FCT connected to an Analog port of the ip office.
When I call out from it (I use it to call mobile phones) and the user hangs up the port gets disconnected OK.
When somebody dials in though and then hangs up the port isn't disconnect and I get a busy tone.
I don't know how much exactly it takes but the port stays busy for about 4-5 and then disconnects.
Is it possible to set up a busy tone detection through the manager so that the port will get disconnected immediately when the tone is heard?
You can listen to the busy tone here:
Thanks
I have an Ericsson FCT connected to an Analog port of the ip office.
When I call out from it (I use it to call mobile phones) and the user hangs up the port gets disconnected OK.
When somebody dials in though and then hangs up the port isn't disconnect and I get a busy tone.
I don't know how much exactly it takes but the port stays busy for about 4-5 and then disconnects.
Is it possible to set up a busy tone detection through the manager so that the port will get disconnected immediately when the tone is heard?
You can listen to the busy tone here:
Thanks