Disconnect supervision on analog ports

[aragon]

Option 11C 25.40
Universal trunk port.
I am trying to enable disconnect supervision on analog station port to external cpe trunk port.
How can this be done?

David Brillert

http://www.williamsglobal.com

 

[shroud]

Not too sure if I understand your question, however the answer supervision is provide by the CO on the Trunk circuit, and for each Trunk circuit on the pabx there is a SUPN Y/N setting which can be programmed in LD 14.

 

[johnpoole]

if you need to provide supervision, on the trunk answer the supervision no... meaning you are not expecting supervision from the far end, and in the rdb answer the nedc and fdec prompts as org... near end disconect control, will release the trunk when the orginating party hangs up...

john poole
bellsouth business
columbia,sc

 

[aragon]

I wish for the PBX to issue disconnect supervision to adjunct CPE trunk port.
There is a voicemail on the adjunct CPE which is not receiving disconnect signal from 11C and this is tying up trunks.

 

[janaya]

are they loop start or ground start analog trunks? I am pretty sure that one of the two is not supported by nortel. I think it's loop start.

I had a customer that had loop start trunks and the mer mail would not disconnect after an announcment. Once we changed to ground start trunks this cleared it up.

John

 

[johnpoole]

both are supported, ground is perfered

john poole
bellsouth business
columbia,sc

 

[aragon]

I don't think anyone understands the question.
I'm not looking for disconnect supervision from a telco.
I want the analog line ports of the M1 to issue a disconnect to the analog trunk ports of a 3rd party PBX.
They would be loop start

 

[johnpoole]

yes my original post tell you how to inform the trunk that supervision depends on the station... near end disconnect, set to org, means the station that made the call controls supervision and that controls tear down...

john poole
bellsouth business
columbia,sc

 

[aragon]

Thanks John,
I have been plugging away in ld10 are these prompts in ld14?
If so I will look them up in MERL

 

[johnpoole]

ld 16 for the fdec prompts, prt the rdb in load 21, make obmissionthe changes is 16, sorry for the brain freeze

john poole
bellsouth business
columbia,sc

 

[RMLEVYM]

I need alert tone in time forced disconnect for a E1 link in Meridian 11C Rls. 25.