Disable/Enable Ip-Interface

[telecomadmin12]

I would like to change the gateway address of my two CLANs. I go to change ip-interface xxxx to enter the new gateway address, but I get following message: "Must disable ip-interface before changing attributes". I don't find a disable, enable ip-interface command, so my question is: how do I disable/enable ip-interface?
8700, CM3.0

 

[Tolson]

Do a change ip-interface xxxx. On that screen there is a field enable: Y set it to N and save. Now go back into the board and make the changes you need and set the enable field to Y. Save it and your done.

 

[telecomadmin12]

Thanks.
Do you mean to set the Enable Ethernet Port: y to n?
And then go to change ip-interface xxxx ,do my changes and then set it back to y.
Is it going to be out of service while it is set to n?

 

[Tolson]

Yes that is the field. You must set it to n and then save it. Then you can go back into the board and make the changes you want and re-enable it and then save it. While it is disables it will be out of service and anything that depends on it will not function.