Dialogic SR140 integration with cs1000e 5.5

[alberto111]

Call From SR140 to nortel cs1000e -succsessfully tested.
Call from nortel to SR 140-Couldnt possible.
In dchannel message showing no route to destination.
Can anyone have any experiance this?

 

[Tman45]

Outbound Dialer, right? We installed a proprietary system and it uses Dialogic boards. We did initially have 'no route to destination' and it ended up being a dchannel protocol mismatch. You will just have to 'play' around with different settings until it finds what it likes. Unless someone else has a specific recommendation.

 

[Skaret]

I had the same issue this week for a new installation of Dialogic SR140 integration with cs1000e 5.0 (SIP). Problem was related to the following issue:

* Configuration of EM (SIP URI Map, Private/UDP domain name and Private/CDP Domian name) need to be the same as configured in the NRS (L0 and L1 domain).

* Entpoint in NRS, for SR140, need to be set to UDP transport - not TCP transport. Be sure you use the same port configured in the SR140.