Deny IB telemarketing number

[Naperguy1]

We are having a nuisance caller from the caribbean disturbing the peace. The CDR reports 19999999999 on the dialed number. Only one person has complained about it so I setup a VDN to Vector 10 checking for the ANI and routing it to a busy signal. I am manipulating the persons DID to get to the VDN and follow vector processing. Works good. Then, I got curious and did a report in our CDR system and found out that there are approximately 20 people who have received calls from the same ANI this year alone. How can I block it totally for everyone without creating separate vectors for everyone? Thank you in advance.

I have temporarily rerouted the calls to my extension to catch them otherwise step 8 would have busy. Below I posted the vector. I am using ISDN incoming call treatment to reroute the person's DID to the VDN 1016 (pointed to vector 10 - below).

Trunk group:

INCOMING CALL HANDLING TREATMENT
Service/ Called Called Del Insert Per Call Night
Feature Len Number CPN/BN Serv
public-ntwrk 4 4304 4 1016

CALL VECTOR

Number: 10 Name: TLoeb - TMktr
Multimedia? n Attendant Vectoring? n Meet-me Conf? n Lock? y
Basic? y EAS? y G3V4 Enhanced? y ANI/II-Digits? y ASAI Routing? n
Prompting? y LAI? n G3V4 Adv Route? y CINFO? y BSR? y Holidays? y

01 wait-time 2 secs hearing silence
02 goto step 8 if ani in table 1
03 route-to number 4304 with cov y if unconditionally
04 stop
05
06
07
08 route-to number 4553 with cov n if unconditionally
09 stop
10
11

Thank you all.

Naperguy1

 

[DFM]

Are you using ISDN for inbound?

How many digits is the CO sending you?

 

[SF0751]

Do you have EC500 available? See thread690-543688 for a tip on using this to block specific inbound ANI's without having to use vectors.

Susan
"Few things are harder to put up with than the annoyance of a good example." - Mark Twain, Pudd'nhead Wilson (1894)