Default IP Small Office Edition 1

[tdaugirdas]

Trying to default an IP Small Office via the DTE port. Get to loading 70% of the IP401 bin file - and the process chokes - and goes back to a multi-sector erase - repeats the load attempt - and chokes again - ad nauseum.

I am using Manager 4.15 and using the IP401 bin file. Should I go back to an earlier release of IPO? Is the loader big enough (memory-wise) on the Small Office or do I have to do something special to get it to work.

The unit currently has a "red" error light and is basically useless and can't be accessed normally.

Tom Daugirdas,
President
STCG, Inc.
stcg.com

 

[tlpeter]

It should fit but try the 3.2.999 loader first


ACA - Implement IP Office
ACS - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!

 

[tdaugirdas]

When you say "loader" do you mean the 401ng bin file in that 3.2999 folder or some other file first?? I tried the 401ng file in that folder - and it still chokes at 70%. There is also an "nadcpv2" file in that folder. I think I have tried every ip401ng file I can find (going back to 3.0.999 - and so far they all choke at 70%. Is there any document that spells out the default/upgrade procedure for an IP Small Office. I have no idea of the current firmware - since I cannot connect to it normally via Manager. All I get from Hyperterminal on initial connection is: Programming FPGA; FPGA Version 89; Ethernet Switch: Port ID=520, PhyId1/2=0410C1F; P6 Loader 1.1; CPU Revision 0x0502 - and that's it - it then does a full sector erase and tries to load the ip401ng bin file and chokes at 70% complete - then restarts the whole process all over again. I have pointed to various 401ng bin files in the Boot settings - but can't seem to find one that will go beyond 70%. I don't know how far I should go back in bin files.

Tom Daugirdas,
President
STCG, Inc.
stcg.com

 

[tdaugirdas]

Never mind - I'm an idiot again at 1:00am!! I had the boottp pointed to the correct bin file - but did not change my working directory settings to match - so it kept trying to load the WRONG ip401 bin file. Changed the working directories and VOILA - it successfully loaded the 3.2.999 bin file!!

Tom Daugirdas,
President
STCG, Inc.
stcg.com

 

[tlpeter]

Great you have it working again


ACA - Implement IP Office
ACS - Implement IP Office
ACA - Voice Services Management
______________
Women and cats can do as they please and men and dogs should relax and get used to the idea!