Daylight savings setting

[noisecode]

When I run "set time" I change time from "standard" to "daylight savings". When I try to enter this, it says I must verify the date/time. I re-enter date and time but it still says this. Is there another setting I need to change? I have setup the daylight savings rules and set the set time form to use these but it is not working. Any help would be appreciated. Thanks!

 

[1a22ip]

check the locations page. Type change locations and make sure the same Daylight rule is there as well.

Hope this helps
ED


1a2 to ip I seen it all

 

[noisecode]

Yes, the daylight savings rule is in locations.

 

[1a22ip]

What release are you running? If you have CM2 and above use the time server on the S8700.



ED

1a2 to ip I seen it all