D Channel creation

[sfcstroud]

Situation: Vendor requires 3 pri's each with d-channel. When parts arrived there is only 1 Dchannel Daughter Board.
2 Pri's are going to external conference bridge
1 Pri is going to outbound dialer for emergency operations.
Loops created are 77, 78, and 88. My recommendation to the technician was to create Dchannel 77 and supply that to both loops 77 and 78, then use the 2nd dchannel for loop 88. Additionally SQ(Stupid Question)do i have to have a dch daughter board to create dchannels that I am providing clocking.
Switch info: 81C, Succession 3.0, CP 4.0

 

[johnpoole]

clocking is a second issue.. you need a single clock controller min for that.. you can not share a d unless both ends are to the same provider.. in your example that would require a min of two.. i can't get and send setup and teardown to external and expect it to get to the conf bridge.. one for each end point..

john poole
bellsouth business
columbia,sc