Hi,
I need some help in setting up a private SIP trunk and NRS between CS1k Rel5 (CPPM based sig server) and BCM450 Rel5
we do not have a sip trunk from a carrier
sip domains defined in NRS
Service and L1 domain (comp.sip) and L0 domain (cdp.comp.sip)
cs1k has SIP Access ports ISMs , BCM has SIP trunk licenses
I was following a few threads and the solution integration guide ... till i got stuck
1. Created a virtual superloop
2. Created a D channel
3. Created a zone
4. Created a Route
5. Created 2 trunks in the new Route
6. Created RLI to use Route as the only choice
7. Created DSC
8. Verified Codec and QoS settings
In sig server properties - it is currently setup for H323 only - when i change to SIP and H323 and try to transfer - the system comes with an error message enter e.164/national and subscriber domains ( i tried entering country code and area code info)
The next place i got stuck was @ Gateway authentication password
Require help and guidance in proceeding this
I need some help in setting up a private SIP trunk and NRS between CS1k Rel5 (CPPM based sig server) and BCM450 Rel5
we do not have a sip trunk from a carrier
sip domains defined in NRS
Service and L1 domain (comp.sip) and L0 domain (cdp.comp.sip)
cs1k has SIP Access ports ISMs , BCM has SIP trunk licenses
I was following a few threads and the solution integration guide ... till i got stuck
1. Created a virtual superloop
2. Created a D channel
3. Created a zone
4. Created a Route
5. Created 2 trunks in the new Route
6. Created RLI to use Route as the only choice
7. Created DSC
8. Verified Codec and QoS settings
In sig server properties - it is currently setup for H323 only - when i change to SIP and H323 and try to transfer - the system comes with an error message enter e.164/national and subscriber domains ( i tried entering country code and area code info)
The next place i got stuck was @ Gateway authentication password
Require help and guidance in proceeding this
