I am working with tamtron on this BarCode issue. The bar code reader works on all other applications but it is at this one point in the Tamtron program where the Vendor is writing the script for the Specimen label. It appears that after the label definition there needs to be a command to advance to the next field. In the Bar Coder Program it used <Enter> to advance but in code 3of9 which we are using in this application We can't figure out how to add it to the command string
EXAMPLE
If <> "Barcode command *enter sample ID here*" where the "*"'s are the 3of9 start and stop char's then is there a way to enter a command at the end otf this string to say "then <Enter>" the code 3of 9 command is "I$" for "Tab" but I'm not sure where to or how to put this into that definition. I have talked to the BarCodeer vendor and all of the settings are correct for their side. I'm asking here because the hang up seems to be in the Crystal Report build for the Label definition.
Thanks
OldLoady
EXAMPLE
If <> "Barcode command *enter sample ID here*" where the "*"'s are the 3of9 start and stop char's then is there a way to enter a command at the end otf this string to say "then <Enter>" the code 3of 9 command is "I$" for "Tab" but I'm not sure where to or how to put this into that definition. I have talked to the BarCodeer vendor and all of the settings are correct for their side. I'm asking here because the hang up seems to be in the Crystal Report build for the Label definition.
Thanks
OldLoady