CPU Question 81C Rel 4.0 1

[KillianK]

Hi All,

I normally connect to CPU 0, I connected to the redundant CPU 1 and I noticed that there is no CDB or any config? Is this correct, that only the active CPU show the current config? If I use the JOIN command, will this sync the CPU's and copy the CDB, etc. Do I run the join command on the active CPU or the Redundant? Or is there another way of transferring the data to cpu's?

Thanks in advance,

Killian

 

[johnpoole]

that's not a good thing.. ld 137 stat, does that show rdun yes? from the active side ld 137 sync.. i wouldn't do that under high traffic, it takes a lot of cpu time

john poole
bellsouth business
columbia,sc

 

[KillianK]

LD 137
.stat cpu

cp 0 16 PASS -- ENBL

SINGLE
DISK STATE = REDUNDANT READY
HEALTH = 26
VERSION = Sep 16 2004, 08:23:50
Side = 0, DRAM SIZE = 256 MBytes

cp 1 16 DSBL: NOT RESPONDING

When in login to CP 1 i get the same message

LD 137
CMDU 0 ENABLED (ACTIVE)
ELNK ENABLED
SDEV 0 OK (KC VALID)

Thanks,

Killian

 

[johnpoole]

cp 1 16 DSBL: NOT RESPONDING

do you have a faceplate switch off or in maint? i would get a new cpu asap

john poole
bellsouth business
columbia,sc

 

[KillianK]

Thanks John, I reloaded the Software on CP 1 and it came back up, plus the gig crossover cable was in LAN 1 on both CPU's, changed that to LAN 2 on both CPU's and went into standby mode,

Cheers,

Killian