Correct the setting

[daveask]

Hi,

It must be a very simple question, but....
Every time, when I switch on a Windows se, it said
Not ready reading drive A
I just cannot find where to correct the setting.
I tried press Del when switch on snd got into the setting window but cannot find anything can do that....

Thank you for any help.

 

[edfair]

Does the floppy drive select light come on during the boot up sequence.
You might want to change the CMOS to enable "seek on post", that way the light should come on twice.
No light, drive disconnected, no power, defective, or the controller is bad. Or possibly the floppy drive swap has been enabled.

Ed Fair
Give the wrong symptoms, get the wrong solutions.

 

[daveask]

Ed Fair,

Thank you. But I cannot find "seek on post",