Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Convert DWG to PDF
- Thread starter wkszd
- Start date
WICKERBSKT
Programmer
WHAT PROBLEMS HAVE YOU HAD WITH DISTILLER- WHEN PLOTTING THERE IS NOT MANY SIZES TO CHOOSE FROM, HOWEVER THERE IS A WAY AROUND THIS, FOR 24x36 (JUST AN EXAMPLE)
PLOT TO DISTILLER
GO TO PROPERTIES
CUSTOM PROPERTIES
ADVANCED
PAPER SIZE- CHANGE TO POST SCRIPT CUSTOM PAPER SIZE
ENTER YOUR PAPER SIZE
OK 4 TIMES AND THEN CHECK YOUR PLOT AREA SIZE IT SHOULD WORK
HOPE THIS HELPS-ERIC @ BENCHMARK ENGINEERING INC.
PLOT TO DISTILLER
GO TO PROPERTIES
CUSTOM PROPERTIES
ADVANCED
PAPER SIZE- CHANGE TO POST SCRIPT CUSTOM PAPER SIZE
ENTER YOUR PAPER SIZE
OK 4 TIMES AND THEN CHECK YOUR PLOT AREA SIZE IT SHOULD WORK
HOPE THIS HELPS-ERIC @ BENCHMARK ENGINEERING INC.
SerialCoder
Programmer
I have spent countless hours messing with pdf's from ACAD. I have acrobat 6 pro which has "better" support for ACAD but still fount it to be real quirky. I purchased AcroPlot and it rocks. It was very consistant and intuitive to the CAD needs. Especially usefull for batching entire folders into a single pdf.
- Status
Similar threads
- Locked
- Question