Connecting WIC-1T ---> Serial A/S Port !

[Phi486]

Hello,
Does anyone know for sure if Cisco WIC-1T high-speed card installing in Router-2620 can connect directly to a Serial Asyc Port (low speed) S2 or S3 of Router-2520 using DTE/DCE 60-pin cable safely? Cisco shows that this WIC-1T will not support Asyn max speed. Does this mean they can't be connecting to each other? Has anyone tried this without any hardware damaging problem, please advice.

http://www.cisco.com/warp/public/107/hw_1t_wic.shtml

Thanks in advance!

Phi

 

[burtsbees]

If you are trying to build a frame relay switch, I would just go to Ebay---I got my 2503 for $25. I have no idea what you are actually doing, but I did think the same thing, but did not research it too much---just decided that it cannot be done. Just a thought.

Burt

 

[Phi486]

Yes. I am building a frame Relay switch and it calls for a direct connection between 2 serial ports of 2 devices. The old router 2520 that acts as a frame-relay switch has 2 high-speed and 2 low-speed ports. Only the low-speed ports are my concerns.

Phi