Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Connecting to PBX in a short distance.

Status
Not open for further replies.
oclaudiox

oclaudiox

IS-IT--Management
Jun 18, 2006
52
BR
Hi all,
I have a good and easy question: how can I connect two PABX by DS1 ? My Swithes are near (1 ft). Can I connect directly a DS1 to another one ?

Is it clear question ?

Thanks a lot.

Claudio.
 
Sort by date Sort by votes
I would say yes. As long as you pin your connection out correctly, this should work just fine.

Scott m.
 
Upvote 0 Downvote
Great !!!

Please mega, dou you have a example of tie trunk config page ?

There is any special configuration ?

Thanks again.

Cláudio
 
Upvote 0 Downvote
Here is one of my tie lines:

Code: 
display trunk-group 16                                          [COLOR=red]Page   1 of  10[/color]
                                TRUNK GROUP

Group Number: 16                   Group Type: tie           CDR Reports: y
  Group Name: Police                      COR: 59       TN: 1        TAC: 720
   Direction: two-way        Outgoing Display? y Trunk Signaling Type:
 Dial Access? y                Busy Threshold: 99        Night Service:
Queue Length: 0                                   Incoming Destination:
   Comm Type: avd                   Auth Code? n
                                  Trunk Flash? n
         BCC: 0
TRUNK PARAMETERS
   Trunk Type (in/out): immed/immed      Incoming Rotary Timeout(sec): 5
    Outgoing Dial Type: tone                       Incoming Dial Type: tone
                                              Disconnect Timing(msec): 500
       Digit Treatment:                                        Digits:
                                                    Sig Bit Inversion: none
     Analog Loss Group: 9                          Digital Loss Group: 13
    Incoming Dial Tone? y
              Bit Rate: 1200         Synchronization: async    Duplex: full
 Disconnect Supervision - In? y  Out? y
 Answer Supervision Timeout: 0             Receive Answer Supervision? y
                                                             [COLOR=red]Page 2 of 10[/color]
TRUNK FEATURES
          ACA Assignment? n            Measured: none
                                 Internal Alert? n        Maintenance Tests? y
                               Data Restriction? n

            Used for DCS? y  PBX ID: 5
   Suppress # Outpulsing? n
                    Seize When Maintenance Busy: neither-end




Incoming Tone (DTMF) ANI: no                   Per Call CPN Blocking Code:
         Connected to CO? n                  Per Call CPN Unblocking Code:

                                                    Ds1 Echo Cancellation? n

                                                                    [COLOR=red]Page 3 of 10[/color]
 ADMINISTRABLE TIMERS

   Incoming Disconnect(msec): 500             Outgoing Disconnect(msec): 500
   Incoming Dial Guard(msec): 70              Outgoing Dial Guard(msec): 1600
  Incoming Glare Guard(msec): 1500           Outgoing Glare Guard(msec): 1500



                                         Outgoing Seizure Response(sec): 5
 Programmed Dial Pause(msec): 1500         Disconnect Signal Error(sec): 240
          Flash Length(msec): 540   Incoming Incomplete Dial Alarm(sec): 255





END TO END SIGNALING
    Tone(msec): 350      Pause(msec): 150

OUTPULSING INFORMATION
     PPS: 10    Make(msec): 40   Break(msec): 60
                                                                  [COLOR=red]Page 4 of 10[/color]
                                 TRUNK GROUP
                                      Administered Members (min/max):   1/22
GROUP MEMBER ASSIGNMENTS                  Total Administered Members:  22

       Port    Code Sfx Name        Night           Mode      Type   Ans Delay
  1: 01D1801  TN767  E
  2: 01D1802  TN767  E
  3: 01D1803  TN767  E
  4: 01D1804  TN767  E
  5: 01D1805  TN767  E
  6: 01D1806  TN767  E
  7: 01D1807  TN767  E
  8: 01D1808  TN767  E
  9: 01D1809  TN767  E
 10: 01D1810  TN767  E
 11: 01D1811  TN767  E
 12: 01D1812  TN767  E
 13: 01D1813  TN767  E
 14: 01D1814  TN767  E
 15: 01D1815  TN767  E

Hope this helps. I am certainly not the most knowledgeable person in the forum, so there may be parts you need I did not include. Keep in mind this is a DCS connection.

Scott m.
 
Upvote 0 Downvote
Hey man, thanks a lot.

I need do a test.
I will post results here.

In Brazil, we say:
"VALEU, MEU CAMARADA !!!"

Claudio.
 
Upvote 0 Downvote
I have done the same kind of thing, but the PBX's connected were about 100 yards apart. Pinned out as a T1 crossover and set my trunk groups up accordingly. Had to use PRI boards with integrated CSU's for what I was trying to accomplish.

We must all hang together, or assuredly we shall all hang separately.
 
Upvote 0 Downvote
My trunk group (on the main side) looks like this:


Code: 
Group Number: 7                    Group Type: isdn          CDR Reports: y
  Group Name:                             COR: 1        TN: 1        TAC: 67
   Direction: two-way        Outgoing Display? y
 Dial Access? n                Busy Threshold: 23          Night Service:
Queue Length: 0
Service Type: tie                   Auth Code? n            TestCall ITC: rest
                         Far End Test Line No:
TestCall BCC: 4
TRUNK PARAMETERS
         Codeset to Send Display: 6     Codeset to Send National IEs: 6
        Max Message Size to Send: 260   Charge Advice: none
  Supplementary Service Protocol: a     Digit Handling (in/out): enbloc/enbloc

            Trunk Hunt: cyclical
                                                   Digital Loss Group: 13
Calling Number - Delete:     Insert:                 Numbering Format:
              Bit Rate: 1200         Synchronization: async    Duplex: full
 Disconnect Supervision - In? y  Out? n
 Answer Supervision Timeout: 0                       

TRUNK FEATURES
          ACA Assignment? n            Measured: none      Wideband Support? n
                                 Internal Alert? n        Maintenance Tests? y
                               Data Restriction? n     NCA-TSC Trunk Member:
                                      Send Name: y      Send Calling Number: y
            Used for DCS? y  PBX ID: 4
   Suppress # Outpulsing? n    Numbering Format: public    DCS Signaling: d-chan
 Outgoing Channel ID Encoding: exclusive     UUI IE Treatment: service-provider

                                                 Replace Restricted Numbers? n
                                                Replace Unavailable Numbers? n
                                                      Send Connected Number: n


               Send UCID? n
 Send Codeset 6/7 LAI IE? y                         Ds1 Echo Cancellation? n

                                          US NI Delayed Calling Name Update? n

                            Network (Japan) Needs Connect Before Disconnect? n

                                 TRUNK GROUP
                                      Administered Members (min/max):   1/23
GROUP MEMBER ASSIGNMENTS                  Total Administered Members:  23

       Port    Code Sfx Name        Night           Sig Grp
  1: 01D0501  TN464  F                                1
  2: 01D0502  TN464  F                                1
  3: 01D0503  TN464  F                                1
  4: 01D0504  TN464  F                                1
  5: 01D0505  TN464  F                                1
  6: 01D0506  TN464  F                                1
  7: 01D0507  TN464  F                                1
  8: 01D0508  TN464  F                                1
  9: 01D0509  TN464  F                                1
 10: 01D0510  TN464  F                                1
 11: 01D0511  TN464  F                                1
 12: 01D0512  TN464  F                                1
 13: 01D0513  TN464  F                                1
 14: 01D0514  TN464  F                                1
 15: 01D0515  TN464  F                                1

etc...


We must all hang together, or assuredly we shall all hang separately.
 
Upvote 0 Downvote
Please,
One of my switches dont have ISDN feature. I want connect by Tie configuration.

My configuration is like that showed by SRMEGA41, but when I do a teste, I receive...

01A0601 TIE-DS1 50/01 136 FAIL
01A0601 TIE-DS1 50/01 36 PASS

In the other switch...
01C0501 TIE-DS1 50/01 136 PASS
01C0501 TIE-DS1 50/01 36 ABORT 1006

What happen ?

Special configuration in DS1 circuit pack ?

Claudio.
 
Upvote 0 Downvote
OK.

Do you have data modules set up?

What happens if you do a "status link X" where X is the link number?

If you do a "status trunk x" where x is the trunk group, what does that say?

We must all hang together, or assuredly we shall all hang separately.
 
Upvote 0 Downvote
Hey man, Im late, but ...
Dont have links to do this test, but, when I do status trunk, I get ...

"50/01 01A0601 in-service/idle no".

But, when I do a teste trunk or teste board, I get ...

"01A0601 TIE-DS1 50/01 136 ABORT 1005"
"01A0601 TIE-DS1 50/01 36 PASS"

How can I remove clock reference ?

Thanks !!!

Claudio.

 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jjacobs83
  • Locked
  • Question
PBX is sending a "180 Ringing" message with an SDP
Replies
1
Views
430
bignose21
bignose21
Craft01
  • Locked
  • Question
ACM6 answering call by short message
Replies
4
Views
372
Craft01
Craft01
Traveler74
  • Locked
  • Question
how to activate and deactivate MTC on an analog phone in Avaya CM?
Replies
1
Views
359
AvayaTier3
AvayaTier3
hcmbmt
  • Locked
  • Question
Cannot log in to Utility 6.3 when 10 years have passed
Replies
0
Views
305
hcmbmt
hcmbmt
Turtlepuke
  • Locked
  • Question
Putting Someone On Hold Once Joined To A Conference?
Replies
3
Views
474
YPC
YPC

Part and Inventory Search

Sponsor

Back
Top