Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TouchToneTommy on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Confused with dlci command ! 1

Status
Not open for further replies.
haneo

haneo

Programmer
Jan 2, 2002
274
CA
can some one tell me the diffrence between
R(conf-if)#frame-relay local-dlci XXX
AND
R(config-if)#frame-relay interface-dlci XXX

because i see the two commands in diffrent docs ??? thx
 
Sort by date Sort by votes
Use the command `frame-relay interface-dlci', the other is used in some test situations. The local command is not used in a `normal' frame relay situation.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

CPM86
  • Locked
  • Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
525
CPM86
CPM86
BleuBell
  • Locked
  • Question
Command Rejected : Exceeded NNI ports Allowed
Replies
0
Views
302
BleuBell
BleuBell
WinstonCH
  • Locked
  • Helpful tip
What is wrong with the diagram, there are people who will help to fix it? How do i do the configurat 1
Replies
1
Views
863
BIS
BIS
dogg1
  • Locked
  • Question
CUCM SNMP Set Command
Replies
1
Views
616
whykap
whykap
inlsp05
  • Locked
  • Question
2811 ios start with cf
Replies
0
Views
326
inlsp05
inlsp05

Part and Inventory Search

Sponsor

Back
Top