Configuring full duplex on sco-unix

[ROYTRUE]

Thanks in advance for any input. How can I configure my nic card with the following configuration:

100mbps
Full Duplex

I can't seem to get to this. I have a Cisco 3548XL switch that is configured with full duplex and 100mbps that has the applicable INT Eth port configured However, I am getting alot of runts on my status. Therefore I believe that it is a config issue on the nic card on the unix box. Any help would be greatly appreciated.

Regards,

Roy True

 

[Annihilannic]

Hop into netconfig, tab down to your adapter, choose "Hardware, Moidfy hardware configuration", jump to "Advanced Options" and there's a pull down menu there. Annihilannic.