Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Configure "Rogue" ports to disable

Status
Not open for further replies.
nicks60610

nicks60610

MIS
Joined
Mar 14, 2002
Messages
711
Location
US
I know you can automatically configure a bad port to disable itself so that it does not affect the traffic on the other ports as it is sending and receiving bad packets. Has anyone done this on 2948XL's and what was the general reaction/success?

Thanks,
 
Status
Not open for further replies.

Similar threads

woza
  • Locked
  • Question Question
GNS3: Delete the lines "transport preferred none"
Replies
1
Views
748
DrB0b
DrB0b
B
  • Locked
  • Question Question
Cisco IP phone 7841 8851 unable to forward all to external number
Replies
0
Views
403
badwolf1686
B
CPM86
  • Locked
  • Question Question
Cisco isr 4331 with IOS and sip busy fail over to 2nd sip number on pbx?
Replies
0
Views
558
CPM86
CPM86
Luzbel
  • Locked
  • Question Question
Connecting HVAC controller to network
Replies
0
Views
575
Luzbel
Luzbel
Skip Rango
  • Locked
  • Question Question
how to backup cisco sg500-52p switch
Replies
1
Views
798
madwok
madwok

Part and Inventory Search

Sponsor

Back
Top