TiggermanW
IS-IT--Management
I just finished a phone system migration in the building here and have run into a small problem.
The 3 elevators were on an analog port of the old (lucent) phone switch. The phone switch was configured such, that when the port was picked up, it autodialed the elevator emergency number.
Is it possible to do this on my Nortel 0x32 system, running MICS 4?
I have the three elevators connected to a single ATA2 device. (While I can have two of the elevators reconfigured to auto dial, the 3rd elevator just has an analog phone in it, and I am trying to avoid from having to call the elevator company and have them upgrade it to a new autodialer.)
The 3 elevators were on an analog port of the old (lucent) phone switch. The phone switch was configured such, that when the port was picked up, it autodialed the elevator emergency number.
Is it possible to do this on my Nortel 0x32 system, running MICS 4?
I have the three elevators connected to a single ATA2 device. (While I can have two of the elevators reconfigured to auto dial, the 3rd elevator just has an analog phone in it, and I am trying to avoid from having to call the elevator company and have them upgrade it to a new autodialer.)
