configure a pri connection to polycom MGC50

[hoffdog]

Trying to set up a pri connection between an 8710 using a TN464F and a Polycom MGC 50 using a net4 card. I have configured the ds1, trunk group, and sig group. Have tried it a billion different ways. Tried it with a t-1 straight through cable and a T-1 Crossover cable. I cannot get this to work at all. Out of service near end no matter what I do. Anyone made this setup work before. We have a PRI from At&t going straight to the polycom we wanted to run one through the pbx also for additional lines and a backup. Thanks in advance for any help you guys can offer.

Ed

 

[hoffdog]

Please disregard as I am mentally retarded. When I did my T-1 Crossover cable I crossed the wrong pair, did a cat 5 instead of T-1. Guess I need to slow down a bit and not auto pilot so much when making my cables.