I POSTED THIS TWO DAYS AGO WITH A POOR SUBJECT DESCRIPTION
Just downloaded and installed the reports dist. expert and am trying to use it in 8.5 developer. The "analyzing files" step is interrupted by a message that says something like, "the database must be set to "same as report", go back in design and set it or the report WILL NOT WORK." However after I exited the RDE, I found that it did compile the report. I went back into the report anyway and set the database location to "same as report" and tried to run the distribution routine again. I got the same error message. It compiled the report again only this time the .exe wouldn't run because it couldn't find the database. There is nothing in Crystals KB about this error (surprise!) Has anyone else seen this message and is there a workaround? Thanks!
Just downloaded and installed the reports dist. expert and am trying to use it in 8.5 developer. The "analyzing files" step is interrupted by a message that says something like, "the database must be set to "same as report", go back in design and set it or the report WILL NOT WORK." However after I exited the RDE, I found that it did compile the report. I went back into the report anyway and set the database location to "same as report" and tried to run the distribution routine again. I got the same error message. It compiled the report again only this time the .exe wouldn't run because it couldn't find the database. There is nothing in Crystals KB about this error (surprise!) Has anyone else seen this message and is there a workaround? Thanks!