Compile from VBA Code 2

[kentover]

I have a macro that runs some code to turn off the applications close functionality. I run this on the DB front-end before releasing it out on the network. What I would like to do is add a line in a macro or some code to compile the DB after that occurs.

I have found a few threads that refer to a command line "/decompile" switch but not a "/compile" switch...

Any direction on this? Thanks in advance for your help.

KO

 

[psemianonymous]

RunCommand acCmdCompileAndSaveAllModules

 

[kentover]

Works like a champ. Thanks a lot Foolio!