Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Commands

Status
Not open for further replies.
As every connection must have an xlate slot you could use;

pixfirewall# sh xlate count
60 in use, 722 most used

Chris.

**********************
Chris A.C, CCNA, CCSA
**********************
 
Below is what I get when I type sh xlate count

PIX520UR# sh xlate count
usage: show|clear xlate [global|local <ip1[-ip2]> [netmask <mask>]]
[gport |lport <port1[-port2]>]
[interface <if1[,if2]>]
[state <static[,portmap][,norandomseq][,identity]>]
[debug]
Type help or '?' for a list of available commands.


Cisco Secure PIX Firewall Version 5.1(5)
Compiled on Fri 22-Jun-01 20:15 by morlee
Finesse Bios V3.3

PIX520UR up 43 days 22 hours

Hardware: AL440LX, 128 MB RAM, CPU Pentium II 233 MHz
Flash AT29C040A @ 0x300, 2MB
BIOS Flash AM28F256 @ 0xfffd8000, 32KB

Licensed connections: 128

sh conn
151 in use, 9472 most used

If the license shows 128 connection and when I type sh conn it show 151 does it mean that 22 are not connected??

 
128? What does the output of 'sh activation-key' give?

Chris.

**********************
Chris A.C, CCNA, CCSA
**********************
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top