Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Combo Card 700476013 and IPO 9.1

Status
Not open for further replies.

gberger

Technical User
Mar 2, 2004
1,328
CA
We might upgrade an IPO 6.0 to 9.1 and i would like to know if that combo card is supported on 9.1
Part number is: 700476013 and DLC8 is: 700417330

Thanks
 
700476013 is a Combo Card - 6 Digital Stations, 2 Analogue Stations, 4 Loop Start CO Trunks

700417330 is a Digital Station 8 - 8 Digital Stations only.
 
Thank you both,

Anything to check other then the cfg size(6.0 bug)to ensure smooth upgrade?
As i understand i have to go from 6.0 to 8.0 then 8.0 to 9.1?
 
Inane case you have to go throug a late 8.1(>.65) or 9.0 to increase the boot loader.
 

So what you are saying is that i should go from 6.0 to 8.0, then from 8.0 to 8.1, then from 8.1 to 9.1?
Am i right?
 
I'm pretty sure someone here knows the next steps to get. I think from 6.0 to 8.0 (but an earlier release) is OK and creates a virtual essential edition. Then go to any 9.0 and further to 9.1.

But to be sure I would have to read the GA release notes.
 
Pre-8.0 control unit needs to upgrade via 8.0 to get virtual essential license, if desired. Any expansion modules need to upgrade via 8.0 to get proper loader. I don't believe that base cards need to upgrade via a particular release, above and beyond what base controller itself requires.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top