CM2.2 Built-in 6-way conference bridge

[hico]

I'm looking to see if anyone has run accross this. The system is a CM2.2 utilizing the built-in 6-way confertence bridge. There are two VDNs set up to access the conference feature. Calls to one of the VDNs don't seem to be releasing therefore loocking up the bridge. The second VDN doesn't eveer have this problem. Any ideas??

 

[Mitch672]

the VDN points to a Vector, copy & paste each vector here, so we can look at them.

mitch


AVAYA Certified Specialist

 

[hico]

They already removed the vector to try to rebuild everything but can't remove the VDN because the system says it is in use. Reset system 1???

 

[Mitch672]

no, try changing the VDN to another vector # that is setup for meet-me conferencing. There used to be a "busyout meet xxxx" and a "release meet xxxx" you can try that too.

mitch


AVAYA Certified Specialist