Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations Chriss Miller on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

CM status

Status
Not open for further replies.

msk69

MIS
May 29, 2020
335
PK
How can i check the redundancy status of CM from ASA?? I mean to check if the two CM are in Active/Standy mode or not or in a split state??
 
Status Summary from webUI or command 'server' if connected via CLI.
 
Server command giving error from ASA, should i putty CM and run server?? though i wanted to know both CM status from ASA.
 
Yes. the 'server' command is ran from the CLI. use putty. or get it from the webUI. ASA isn't going to give you want you need. 'list survivable-processor' might be good enough for you? That command you can run from ASA.
 
Thanks for the help..it is showing the required status.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top