CLIPPER 5.3 - LLIBG error

[pboby]

use the Clipper 5.3B and BLINKER6
When use the LLIBG.lib in the my application for function MHIDE() and
MSHOW() for use mouse
generate this error

BLX286 : line 39 in INFOCxxx
Called line 158 in VLIC
Called line 0 in FER
Called line 0 in SHADOW

BLX286 : 1313 : exception error 0D : general protection fault, code =
0000h

Active host is DPMI (v6.00 iP? 65535 Kb)

Reg Value Limit Base Flags Segment Module File
CS 017F F2A3 84187500 FB00 0E INFOCONT
C:\...TOT1\INFOxxx.EXE
DS 0000 ****
ES 0367 03FF 845D01A8 F300 ****
SS 01E7 FFFF 84177500 F300 1B INFOCONT
C:\...TOT1\INFOxxx.EXE

[Code byte CS] C5 76 0A 8B 4E 0E D1 E9 [IP] F3 A5 73 01 A4 1F 5E 5F 8B E5

[Registers] AX=0002 BX=1D40 CX=0001 DX=0367 CS:IP=017F:BC34
SI=0416 DI=0010 BP=7CDA SP=7CD4
FL=0202 NV UP EI NT PL NZ NA PO NC

[Stack value SS] 000A 000A 0367 0367 7CD4 8938 0030 02CF 2BA0 806A 0001
0000
[SP] 01E7 2BA0 806A 7CFE D3C1 0177 0010 0367 0416 0000 0002
01E7

[Stack frame SS] 0367 7CD4 8938 0030 02CF 2BA0 806A 0001 0000 01E7 2BA0
806A
[BP] 7CFE D3C1 0177 0010 0367 0416 0000 0002 01E7 2BA0 806A
0006


if not use MOUSE and not link LLIBG.lib the application work correct but
no
mouse

I need to use MOUSE but not work this
Whait it problem and what solution exist

 

[DTracy]

You may need to change the screen resolution and also to set the mouse on. See the Norton NG or the Clipper 5.3 manual for explaination.

det